Material Safety Data Sheet
Antimony(III) sulfide
ACC# 81769
Section 1 - Chemical Product and Company Identification |
MSDS Name: Antimony(III) sulfide
Catalog Numbers:
AC223590000, AC223591000, AC223595000
Synonyms:
Antimony trisulfide.
Company Identification:
Acros Organics N.V.
One Reagent Lane
Fair Lawn, NJ 07410
For information in North America, call: 800-ACROS-01
For emergencies in the US, call CHEMTREC: 800-424-9300
Section 2 - Composition, Information on Ingredients
|
CAS# |
Chemical Name |
Percent |
EINECS/ELINCS |
1345-04-6 |
Antimony(III) sulfide |
98% | 215-713-4 |
Section 3 - Hazards Identification
|
EMERGENCY OVERVIEW
Appearance: dark gray to black crystalline powder.
Warning! Harmful if swallowed, inhaled, or
absorbed through the skin. Causes eye, skin, and respiratory tract
irritation.
Target Organs: Central nervous system,
respiratory system, gastrointestinal system, eyes, skin.
Potential Health Effects
Eye:
Causes eye irritation. May cause conjunctivitis.
Skin:
Causes skin irritation. Harmful if absorbed through the skin.
Ingestion:
Harmful if swallowed. May cause irritation of the digestive tract.
Inhalation:
Harmful if inhaled. Causes respiratory tract irritation.
Chronic:
Repeated exposure may cause central and peripheral nervous system
damage and digestive tract disturbances.
Section 4 - First Aid Measures
|
Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid imme
diately.
Skin:
Get medical aid immediately. Immediately flush skin with plenty of
water for at least 15 minutes while removing contaminated clothing
and shoes.
Ingestion:
Do not induce vomiting. Get medical aid immediately. Call a poison
control center.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh
air immediately. If breathing is difficult, give oxygen. Do not use
mouth-to-mouth resuscitation if victim ingested or inhaled the
substance; induce artificial respiration with the aid of a pocket
mask equipped with a one-way valve or other proper respiratory
medical device.
Notes to Physician:
Treat symptomatically and supportively.
Section 5 - Fire Fighting Measures
|
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. Dusts at sufficient concentrations can form
explosive mixtures with air.
Extinguishing Media:
Use water spray, dry chemical, carbon dioxide, or chemical foam.
Flash Point: Not available.
Autoignition Temperature: Not available.
Explosion Limits, Lower:Not available.
Upper: Not available.
NFPA Rating:
(estimated) Health: 2; Flammability: 1; Instability: 0
Section 6 - Accidental Release Measures
|
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Vacuum or sweep up material and place into a suitable disposal
container. Wear a self contained breathing apparatus and appropriate
personal protection. (See Exposure Controls, Personal Protection
section). Avoid generating dusty conditions. Provide ventilation. Do
not let this chemical enter the environment.
Section 7 - Handling and Storage
|
Handling:
Minimize dust generation and accumulation. Do not get in eyes, on
skin, or on clothing. Do not ingest or inhale. Use only in a
chemical fume hood.
Storage:
Store in a cool, dry place. Store in a tightly closed container.
Section 8 - Exposure Controls, Personal Protection
|
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use only under a
chemical fume hood.
Exposure Limits
Chemical Name |
ACGIH |
NIOSH |
OSHA - Final PELs |
Antimony(III) sulfide
|
0.5 mg/m3 TWA (listed under Antimony).
|
0.5 mg/m3 TWA (listed under Antimony).0.5 mg/m3 TWA (as Sb) (listed under Antimony compounds).50 mg/m3 IDLH (listed under Antimony).50 mg/m3 IDLH (as Sb) (listed under Antimony compounds).
|
0.5 mg/m3 TWA (listed under Antimony).0.5 mg/m3 TWA (as Sb) (listed under Antimony compounds).
|
OSHA Vacated PELs:
Antimony(III) sulfide:
No OSHA Vacated PELs are listed for this chemical.
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.
Section 9 - Physical and Chemical Properties
|
Physical State: Crystalline powder
Appearance: dark gray to black
Odor: Odorless.
pH: Not available.
Vapor Pressure: Not available.
Vapor Density: Not available.
Evaporation Rate:Not available.
Viscosity: Not available.
Boiling Point: 1150 deg C @ 760 mmHg
Freezing/Melting Point:550 deg C
Decomposition Temperature:Not available.
Solubility: Insoluble.
Specific Gravity/Density:Not available.
Molecular Formula:S3Sb2
Molecular Weight:339.67
Section 10 - Stability and Reactivity
|
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, dust generation, excess heat.
Incompatibilities with Other Materials:
Strong oxidizing agents; acids.
Hazardous Decomposition Products:
Carbon monoxide, oxides of sulfur, carbon dioxide, hydrogen sulfide,
antimony/antimony oxides.
Hazardous Polymerization: Has not been reported.
Section 11 - Toxicological Information
|
RTECS#:
CAS# 1345-04-6:
CC9450000
LD50/LC50:
Not available.
Carcinogenicity:
CAS# 1345-04-6:
Not listed by ACGIH, IARC, NTP, or CA Prop 65.
Epidemiology:
No information found
Teratogenicity:
No information found
Reproductive Effects:
No information found
Mutagenicity:
No information found
Neurotoxicity:
No information found
Other Studies:
Section 12 - Ecological Information
|
Ecotoxicity:
No data available.
No information available.
Environmental:
No information available.
Physical:
No information available.
Other:
Do not empty into drains.
Section 13 - Disposal Considerations
|
Chemical waste generators must determine whether a discarded chemical is classified
as a hazardous waste.
US EPA guidelines for the classification determination are listed in 40 CFR Parts 261.3.
Additionally, waste generators must consult state and local hazardous waste regulations to
ensure complete and accurate classification.
RCRA P-Series: None listed.
RCRA U-Series: None listed.
Section 14 - Transport Information
|
|
US DOT |
Canada TDG |
Shipping Name: |
ANTIMONY COMPOUND, INORGANIC, SOLID, N.O |
ANTIMONY COMPOUND, INORGANIC, SOLID, N.O |
Hazard Class: |
6.1 |
6.1 |
UN Number: |
UN1549 |
UN1549 |
Packing Group: |
III |
III |
Section 15 - Regulatory Information
|
US FEDERAL
TSCA
CAS# 1345-04-6 is listed on the TSCA inventory.
Health & Safety Reporting List
CAS# 1345-04-6: Effective 10/4/82, Sunset 10/4/92
Chemical Test Rules
None of the chemicals in this product are under a Chemical Test Rule.
Section 12b
None of the chemicals are listed under TSCA Section 12b.
TSCA Significant New Use Rule
None of the chemicals in this material have a SNUR under TSCA.
CERCLA Hazardous Substances and corresponding RQs
None of the chemicals in this material have an RQ.
SARA Section 302 Extremely Hazardous Substances
None of the chemicals in this product have a TPQ.
Section 313
This material contains
Antimony(III) sulfide (listed as Antimony), 98%, (CAS# 1345-04-6)
which is subject to the reporting requirements of Section 313 of
SARA Title III and 40 CFR Part 373.
Clean Air Act:
CAS# 1345-04-6 (listed as Antimony compounds) is listed as a hazardous
air pollutant (HAP).
This material does not contain any Class 1 Ozone depletors.
This material does not contain any Class 2 Ozone depletors.
Clean Water Act:
None of the chemicals in this product
are listed as Hazardous Substances under the CWA.
CAS# 1345-04-6 is listed as a Priority Pollutant under the Clean
Water Act.
CAS# 1345-04-6 is listed as a Toxic Pollutant under the Clean Water
Act.
OSHA:
None of the chemicals in this product
are considered highly hazardous by OSHA.
STATE
CAS# 1345-04-6 can be found on the
following state right to know lists: California, (listed as
Antimony), California, (listed as Antimony compounds), New Jersey,
(listed as Antimony), New Jersey, (listed as Antimony compounds),
Pennsylvania, (listed as Antimony), Pennsylvania, (listed as
Antimony compounds), Minnesota, (listed as Antimony), Minnesota,
(listed as Antimony compounds), Massachusetts, (listed as Antimony).
California Prop 65
California No Significant Risk Level:
None of the chemicals in this product are listed.
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols:
XN
Risk Phrases:
R 20/21/22 Harmful by inhalation, in contact with skin and if
swallowed.
R 36/37/38 Irritating to eyes, respiratory system and skin.
Safety Phrases:
S 22 Do not breathe dust.
S 26 In case of contact with eyes, rinse immediately with plenty of
water and seek medical advice.
S 36/37/39 Wear suitable protective clothing, gloves and eye/face pr
otection.
WGK (Water Danger/Protection)
CAS# 1345-04-6: No information available.
Canada - DSL/NDSL
CAS# 1345-04-6 is listed on Canada's DSL List.
Canada - WHMIS
This product has a WHMIS classification of D1B, D2B.
This product has been classified in accordance with the hazard
criteria of the Controlled Products Regulations and the MSDS
contains all of the information required by those regulations.
Canadian Ingredient Disclosure List
CAS# 1345-04-6 (listed as Antimony) is listed on the Canadian Ingredient Disclosure List.
Section 16 - Additional Information
|
MSDS Creation Date: 9/02/1997
Revision #5 Date: 2/26/2008
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no event shall Fisher be liable
for any claims, losses, or damages of any third party or for lost profits
or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if Fisher has been advised of
the possibility of such damages.